There is a round hole in the center of the front handle that allows you to use a long narrow flat head screwdriver to loosen the slotted screw that locks the blade in place. Then you can turn the blade 90 degrees and remove it, replace it, and reverse the process. You need the right kind of screwdriver, one with a blade about 3/16' wide and a quite long stem before the handle, so you can reach the screw. See also I hope this information allows you to resolve this issue. If you need further assistance, please post back with a comment to this thread. If I've managed to answer your question or solve a problem, please take just a moment to rate this post.thanks!

I have an old Bosch jig-saw model no. 1581VS The owner's manual is gone and I finally broke the saw blade. I know - Answered by a verified Appliance Technician. Repair Parts Home Power Tool Parts Bosch Parts Bosch Jig Saw Parts Bosch 1581VS () Jig Saw Parts. Reply: Bosch 1581VS Jigsaw Base Plate. Jig Saws Bosch Power Tools. Jig Saw Blades; Masonry / Concrete Drilling; Metal Cutting, Grinding & Brushing Accessories. For Jig Saws. T-Shank Jig Saw. Service Manual Of Epson Stylus Tx121 PDF Format Summary. - Books On Level 2 Power Distribution And Transmission - Bosch 1581 Vs Jigsaw Blade Change.

Posted on Aug 02, 2011. I am assuming you are asking because you have a CLIC system. Bosch uses a tool-less blade changing system for its jigsaws that it calls 'Clic.' The system makes changing blades fast and simple. Karaoke Dvd Burner Keygen Mac there. Magic Cutter Keygen Free. With the simple blade changing you get with the Bosch jigsaws, it is no problem to change out a dull blade. REMEMBER: SAFETY FIRST LAST AND ALWAYS!!!

Make sure the saw is unplugged or the battery is removed. If you have a blade in there: Hold the saw over a work bench and push the ejector lever to the center of the front of the saw. There is a center stop; you will feel it. The blade will eject and fall out Insert the new saw blade into the plunger until it latches into place. The teeth should face toward the front of the saw. The back of the blade should rest in the groove of the guide roller. The plunger and the guide roller are between the body of the saw and the plate If the blade will not go into the plunger, check the positioning of the slots in the blade.

They should be at the top. Push the ejector lever and try again. Georgia State License Plate Atlanta. Give the blade a yank to check that it is firmly seated. Plug the saw back in or replace the battery and proceed with the cut Use protective gloves when handling blades. They can be sharp and can be HOT.

I hope this helps Please rate FIXYA Thanks Charly May 20, 2011 .